Cable Clamp Generator

Enter the things you want clamped in here, separated by COMMAS, in the form:

s5,m6,s5,h8,s5,h6,s5,h10,s5,m6,s5

Where: s=space, m=mount, h=hole, each followed by a size number. Full instructions below.

Drawing

Overall size 63 x 20

Click on image to save a copy as SVG - open with Inkscape etc.

Drill List

Type	Size	Offset
Mount	6	8
Hole	10	21
Hole	5	33.5
Hole	6	44
Mount	6	55

Full Instructions

There's also an OpenSCAD version here if you want something you can 3D print or CNC mill.

Enter the things you want clamped in here, separated by COMMAS, in the form:

s5,m6,s5,h8,s5,h6,s5,h10,s5,m6,s5

Where:

s<number> inserts a space of the given size.
m<number> inserts a mounting hole of the given diameter.
h<number> or just <number> inserts a clamping hole of the given diameter.

Note you can omit numbers to repeat the last-used value for the letter:

s5,m6,s5,h8,s5,h6,s5,h10,s5,m6,s5

Can be shortened to:

s5,m6,s5,8,s,6,s,10,s,m,s

The first "s5" sets the space size to 5, every "s" after that will use the same value. Likewise the first "m6" sets the mount size to 6 for the rest of the bracket.

Warning

Do not trust the internet!
This is experimental code. You should not trust it. It may be an elaborate hoax.
This could change at any time, even while you're using it. I might break it while changing things. It might be broken right now.
The warranty just expired.