Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
cnc:cnc_adventures:8-mill-something [2019/02/05 10:46]
jin
cnc:cnc_adventures:8-mill-something [2019/02/05 14:02] (current)
jin
Line 37: Line 37:
 So I tightened it up to take the play out. I also cleaned it up a bit while I was in there, and reversed the washer in the housing as the face was slightly worn by the nut. So I tightened it up to take the play out. I also cleaned it up a bit while I was in there, and reversed the washer in the housing as the face was slightly worn by the nut.
  
 +{{ http://​fuddymuckers.co.uk/​gallery/​s/​500/​cnc/​20190205_111144.jpg }}
  
 +I'd say that's a lot better. Still not perfect, but a lot better. Certainly it'll do for now.
  
 ===== Yo Dawg, We Heard You Like Mills ===== ===== Yo Dawg, We Heard You Like Mills =====
  
 +This leads to one of the issues with tools like this - a great idea would be to mill some new end-plates that aren't plastic, and have a deeper pocket to hold an actual bearing. A bit like [[http://​www.jarkman.co.uk/​catalog/​cnc/​russmf70.htm|this guy did]], but of course that leads to taking the mill apart again...
 +
 +So yeah - the problem with a mill or a lathe is you immediately think of ways to make it make better parts for itself and down the rabbit hole we go!
  
 <WRAP center round todo 60%> <WRAP center round todo 60%>
cnc/cnc_adventures/8-mill-something.txt ยท Last modified: 2019/02/05 14:02 by jin
Driven by DokuWiki Recent changes RSS feed Valid CSS Valid XHTML 1.0